Calculators Parts
Buck converter calculator (and boost)
Enter the input and output voltages, the output current, the switching frequency, the inductor ripple you allow and the output ripple you want. For a buck stage the calculator gives the duty cycle, the inductance, the output capacitance with its ESR, the peak inductor current and the load current where the stage leaves continuous conduction. Switch to Boost for the same set of a boost stage.
The equations are those of TI application reports SLVA477 (buck power stage) and SLVA372 (boost power stage), with the diode forward voltage and the efficiency in the duty cycle. The output ripple is the capacitor term plus the ESR term, so the capacitance it asks for already allows for the ESR you entered.
The calculator
The formulas it uses
These are the formulas the calculator shows, copied from its source code. The results in the window above come from the same code as the app.
Buck stage
- D = (Vout + VD) / (η · Vin + VD)
- ΔIL = ((Vin − Vout) · D) / (fs · L)
- L = (Vout · (Vin − Vout)) / (ΔIL · fs · Vin)
- Ipk = Iout + ΔIL / 2
- Cout = ΔIL / (8 · fs · (ΔV − ESR · ΔIL))
- Icrit = ΔIL / 2
Boost stage
- D = (Vout + VD − η · Vin) / (Vout + VD)
- ΔIL = (Vin · D) / (fs · L)
- L = (Vin · D) / (fs · ΔIL)
- Iin = Iout / (1 − D)
- Ipk = Iin + ΔIL / 2
- Cout = (Iout · D) / (fs · (ΔV − ESR · Ipk))
- Icrit = (1 − D) · ΔIL / 2
Sources. TI SLVA477 (buck power stage) and SLVA372 (boost power stage) design equations. The ripple voltage is the capacitor term plus the ESR term.
Simple and Advanced
Simple is the main values, one set of results and a plot. Advanced is the full design view: the operating range with its corners, tolerance and temperature, checks with their margin (a green tick, an amber warning or a red cross), the parts to order with the ratings they need, warnings that give the fact, the number and the fix, and plots over the whole range. A value typed in one view is the same in the other.
The Advanced view also picks the inductor and the regulator from the vendor model library: every row of the list is the whole design worked out with that part, ranked by inductor loss and saturation margin or by total loss. In the app, Place with this model puts the vendor part in the circuit.
In the app it also places the circuit and checks it
In the app, the buttons under the result act on your circuit: Place and run a transient. The circuit is drawn with library symbols, wires, a source and probes, placed at a free spot in the view, and the analysis that checks it runs at once. With parts selected, Apply to the selected parts writes the result into them, as one undo step.
The last tab of the Advanced view, Verify in simulation, places the calculator's circuit and runs it, with measurements whose pass limits are the calculator's own numbers. A row the simulator cannot check says so and why. More in the manual: Buck and boost stage.
Goes with this one
All 17 calculators
Circuit
Parts
- LED resistor
- Op-amp gain
- 555 timer
- Buck and boost stage
- Crystal load capacitors
- Heatsink and junction